Tangent Exeo AMP Troubleshooting Guide download pdf (Page 7)

CONNEC

TIONS

Connection precautions

 When connecting, either disconnect the power plug from

the power outlet or turn off the unit’s power using the

POWER switch (if any).

 Check the left and right channels and connect properly

(Left to L and Right to R).

 Insert the plugs securely. Improper connection can lead to

generation of noise.

E.g. compact disc player

Connect the CD terminals to the OUTPUT terminals on the

compact disc player using the pin-plug cord.

OUTPUT

Recording connections

Connect the REC OUT terminals to

the input (LINE IN) terminals on the tape deck using the

pin-plug cord.

LI NE

(I N) REC PLAY( OUT)

SUB OUT terminals

These terminals are used to connect to an active subwoofer.

Use pin-plug cords to connect the terminals to the INPUT

terminals on the subwoofer.

ACTIVE

SUBWOOFER

(NOT INCLUDED)

Speaker systems

To avoid damaging the speakers with a sudden high-level

signal, be sure to switch the power off before connecting the

speakers.

 Check the impedance of your speakers.

Connect speaker with an impedance of 4 ohms or more.

The amplifier’s red speaker terminals are the + (positive)

terminals and the black terminals are the – (negative)

terminals.

 The + side of the speaker cable is marked to make it

distinguishable from the – side of the cable. Connect this

marked side to the red + terminals and the unmarked side

is the black terminal.

 Prepare the speaker cords for connection by stripping off

approximately 10 mm or less (no more as this could cause

a short-circuit) of the outer insulation. Twist the wires

tightly together so that they are not straggly.

1. Unscrew the knob

2. Insert the speaker cable.

3. Tighten the knob and secure the cable.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Tangent Exeo AMP Troubleshooting Guide Page 7

Comments to this Manuals